2 minute Mezzmo UI hang when started (2.6.7.0)

[hockerd]

I'm new to Mezzmo and have been using it for a few weeks.

I just upgraded to version 2.6.7.0 and have noticed that it takes 2+ minutes to load the UI – I don't remember this happening before. During that 2 minutes the UI is not responding.

I have disabled my anti-virus and that didn't make a difference.

I turned on logging and started Mezzmo and then closed it as soon as it started responding and in the log file, it looks like a long delay happens at: ControlService QueryServiceConfig = 3

557 - Jul 26 19:17:32.281 - (1343348252.281) - [00] - <00> - > Initializing Done!
558 - Jul 26 19:17:32.415 - (1343348252.415) - [00] - <00> - CS > ControlService: QueryServiceConfig = 3
559 - Jul 26 19:19:42.338 - (1343348382.338) - [00] - <00> - CS > ControlService: QueryServiceConfig = 2

After it starts, it seems to work fine and I haven't noticed any problems with the streaming.

More a nuisance than anything but any help would be appreciated.

Thanks,
Doug

[Paul]

Hi Doug,

That is strange & we haven't had other reports like this as yet. Please send us a full set of logs to support [at] conceiva [dot] com and we'll analyze them to determine the problem.

[chrisvdh]

Hi Doug,

That is strange & we haven't had other reports like this as yet. Please send us a full set of logs to support [at] conceiva [dot] com and we'll analyze them to determine the problem.

I also noticed it since the upgrade to 2.6.7.0. When working with the UI it just stops from time to time for about a minute or two. My thinking was that the pc was busy doing something but after reading this post, it might be related to Mezzmo issues. Will run a log.

[Paul]

Thanks for the additional feedback. Once we get the logs, we'll know more.