Philips TV no longer being streamed to?

[Phenomenon101]

Biggest reason I got Mezzmo is one of my TVs is Philips. Unfortunately, Philips has just about the worst DNLA integration, but Mezzmo makes it work (good work Mezzmo!). Found out today after doing a system restore that it's not streaming to it anymore. I just see a 716 Error message at the bottom left side of the program. I tested to see if it could stream to my phone and it did, but any idea what the 716 error means? I searched and couldn't find anything on it.

[Peter]

Hi,
the 716 error is 'resource not found' so this indicates that the TV is trying to contact the Mezzmo server for the file and is either timing out or is getting a 404 file not found. In the logs you sent us it does not show a request for the file so possibly your Firewall is blocking the request or something else on the network is blocking the request, please try temporarily disabling your firewall to see if the file plays and if it still gives the 716 try powering your router off then on again.

[Phenomenon101]

Hi,
the 716 error is 'resource not found' so this indicates that the TV is trying to contact the Mezzmo server for the file and is either timing out or is getting a 404 file not found. In the logs you sent us it does not show a request for the file so possibly your Firewall is blocking the request or something else on the network is blocking the request, please try temporarily disabling your firewall to see if the file plays and if it still gives the 716 try powering your router off then on again.

That's odd. I did both suggestions and still nothing. I did recently recover my computer. Could that have changed a setting? Mezzmo was not part of the recovery so it was installed all over again. Any other method to try?

[Peter]

The recovery of the computer could have changed something, try going to 'Media Server Settings' in Mezzmo and change the port for the Mezzmo server from 53168 to 53169 to see if this helps.

[Phenomenon101]

The recovery of the computer could have changed something, try going to 'Media Server Settings' in Mezzmo and change the port for the Mezzmo server from 53168 to 53169 to see if this helps.

Nope didn't work either. When changing the port I allowed access, but still nothing. I tried without firewalls (both off on the router and windows). The message it gives is instant, but you're saying Mezzmo pings my TV, but the TV somehow never reaches back to Mezzmo?

[Peter]

I had another look at your logs and there is a media server running on your router that is sending a lot of UPnP traffic across the network and this may be flooding the device, can you please try disabling this server on the router to see if this helps?

In the logs there are no requests from devices on the network for the Mezzmo description document so this indicates that the server port is not accessible by the devices.